Each micro-spray pot stake is adjustable by turning the top on/off valve to water from 0 to 8 GPH by releasing drops of water or up to a 2-ft radius half-circle downward fan spray pattern

Use these micro-spray pot stakes to gently water hanging baskets and potted plants

A 25 PSI pressure regulator MLA-25PR and a filter MLFF-41 are highly recommended to be used first at the water source when using these micro-spray pot stakes

Install by running a piece of 1/4-in vinyl tubing to the plant from the 1/2-in poly tubing using a 1/4-in barbed coupler MLT-BXB

Use either of our punch tools MLA-51 or MLA-TOOL to snap a hole into the 1/2-in poly tubing to install the 1/4-in barbed coupler

Push the end of the 1/4-in vinyl onto the top 1/4-in barbed inlet of the stake and by using the built in depth and direction arrow place the stake near the base of the plant

Also use our 1/4-in tees and elbows MLT-ATE to run the 1/4-in vinyl in opposing directions or in tight corners to supply water to these micro-spray pot stakes

With a beginning water pressure of 25 PSI you can run up to 300-ft of 1/2-in poly tubing and install up to 65 of these micro-spray pot stakes

Proudly made in the USA